I'd be willing to check your drawings and make suggestions. One thing I would like to suggest is that you think more about the future than the present when it comes to tech. Sound, lighting, rigging,etc. can all be bought or rented any time. In your original design think mostly about how you will wire and install other stuff later.
In a theater you have 2 major classes of wires, high voltage and low voltage to and you need to run wires from everywhere to everywhere.
If you have budget for a lot of dimmers (200+) and permanent wiring, then go for it, otherwise be sure you have plenty of power available on camlocks so that you can bring in dimmers and/or buy more later.
I would design open decent sized troughs that you can easily lay cable into and then be able to pull it out after the show. That way you don't have to pay for that much wiring upon building the room.
I'd design in hanging points for left right and center speaker clusters so that you just have to hang the speakers you rent or buy later. Think about how you will get temporary wires to these speakers.
I'd also provide pipes for FOH side and front light and if at all possible, I'd provide catwalks to get to all these positions without lifts or ladders.
I'd provide a good grid backstage for flying stuff, but I might only start with a few line sets, but plan for at least 20 to be installed later. I like to see loading gallery at the top, and it is good to be able to operate the fly from somewhere other than the stage. If you can't afford it now, I'd at least plan for it so the mounting infrastructure is in place. I like to be able to walk on top of the grid to add or move line sets, or put in spot lines on a per show basis. A lot of places don't do that and have to bring in big lifts to do any overhead work.
Consider a real loading dock with room to bring in a big truck, but also consider a ramp for bringing in stuff from street level.
Rental drops are usually at least 20' high so your fly should be at least double that plus 10' or so. Part of that 19' can be in the form of a narrow pit.
A Genie lift is very useful for focusing and rigging.
I'd plan a pit for the orchestra even if it is only 4' deep. I'd rather see it deep enough that it can run under the stage a little.
Id also like to see the idea of putting in a couple traps in the stage floor. The stage floor should be designed top be easily and cheaply replaced. A covering of 1/4" Masonite is very popular.
I'd put in comfortable seats. If your guest aren't comfortable they won't come back. Use enough of a rake that short people can see the stage with a tall person in front of them.
If you are a theater that uses technology to make the audience instead of actors lungs, I would design the room to be acoustically pretty dead. Things that you normally would do acoustically to help get the sound from the stage to the audience just get in the way of electronic sound reinforcement.
You can never have too much backstage space. Wing space is very important, but additional space that is accessible through large doors can also help. These doors should be over 10' high, and at least 10' wide. If you can't afford that space at the beginning, then just put in the foundation and build it later.
I'm sure you get the point. If it can be done later then put it off. Think about all of the stuff you would really like and make sure the architect understands that concept. You can rent or borrow lighting and sound equipment, so it doesn't have to be in the budget for the original building. You will most likely come up short and have to make compromises. Don't let those compromises screw up your future.
------------- David M
|